Reset Ink Level Canon MP470

It is basically a modified reset procedure for Canon MP460.

1. Disconnect the power cable.
2. Hold down On/Off button.
3. Reconnect the power cable.
4. With the power button still down, press the Stop/Reset button twice.
5. Release the On/Off button.
6. The printer is now in factory mode (wait until idle is displayed)
7. Press the right arrow button (next to the OK button) repeatedly until Shipping Mode 3 is displayed.
8. Press the OK Button
9. Wait until “Without Cleaning” is displayed and then presss the Stop/Reset button once.
10. A test page should print.
11. Open the cover. (the cartridges should position themselves at the far left – the cartridge removal location)
12. Disconnect the power cable.
13. Remove both cartridges.
14. Close the cover.
15. Reconnect the power cable.
16. Press the On/Off button.
17. Wait until a Replace Cartridges message is displayed. Now insert the cartridges.
18. Wait until the printer is operating in its normal mode. The display shows the normal start menu (ie: Copy).

to view the Ink level

* Check by going to printer ->properties -> maintenance -> view printer status

Read More..

How to Disabling Low Ink Level Notification for Canon IP and MP

1. Push “resume” for 5 seconds for canon IPXXXX. For canon MPXXX you must enter to service mode.
2. Push Power switch then remove power cord.
3. Insert plug power cord while pressing “power switch” at the same time.
4. Push Start/reset by step 2 continue Wait display shown “0″
5. Push + change display from “0″ to “1″
6. Push color button 2 times
7. Push Power switch again , Printer will print 1 page
8. Open cover
9. Unplug power cord
10. Take out ink cartridge #40 and #41
11. Insert plug again
12. Push power switch
13. Open cover (scan cover)
14. Insert ink cartridge #40 and #41 again

Enter to service mode for canon MPXXX

* With the printer powered off but connected to a power source, press the Power button while pressing and holding the Stop/ Reset button.
* When the Power is lit, press the Stop/Reset button two times while pressing and holding the Power button.
* When releasing the Power button and the Stop / Reset button (regardless of order), the printer will move into a service mode. (Waiting for menu selection)

Read More..